Carpet Adhesive

Product Description

Description:

Size: 1 Gal. 
1167 is a solvent-free, latex-resin emulsion adhesive specifically designed for the installation of most marine carpets. 1167 offers excellent resistance to water when fully dry and cured. 1167 is compatible with most all carpet backings and felt back sheet goods. 1167 is non-flammable, freeze-thaw stable and is protected by the CleanGuard® two-stage antimicrobial. CleanGuard® is a specifically formulated broad-spectrum, anti-microbial agent that protects the 1167 from microorganisms, such as mold or mildew, in both the wet and dry state.

For Use With:
1167 Boat Carpet Adhesive is recommended for the following installations:
A. Marine Carpets:
a. Rubber-backed (Marine, waffle, foam)
b. Non-backed (Tufted or woven)
c. Woven polypropylene (ActionBac®)
Not recommended for carpets with vinyl and most urethane backings.

B. Marine Sheet Vinyl:
a. Non-woven fabric, felt
b. PVC

C. Subfloor Surfaces:
a. Concrete (clean and fully cured) Max. MVER 5 lbs./1000 sq. ft./24 hours, pH 7.0-9.0
b. Asphalt paving (clean and fully cured)
c. Other clean, sound paving surfaces
d. Fiberglass*
e. Aluminum*
f. Marine Grade Plywood
Do not use over asphalt roofing or pressure treated wood decking. Before beginning installations with backing systems or over sub-floors not mentioned above, please contact Technical Services for recommendations. *Clean and lightly abraded to provide for a mechanical bond.

Specific Technical Information:
A. Base: Latex Resin
B. Color: White
C. Non-Flammable
D. Freeze-thaw Stable–Thaw out at room temperature (70ºF+) for a minimum of 24 hours before using. Do not stir
adhesive while ice crystals are present.
E. Clean-up: wet adhesive with warm water, dry adhesive with safety solvent
F. Size: 1 gallon
Installation Recommendations:
1. Sub-floor surface must be sound, smooth and free of loose paint, varnish, curing agents, parting compounds, oil grease,
wax or any other foreign agents or contaminates that could affect the adhesive and bond strength.
2. Minimum environmental conditions are 65º-95ºF for both the floor covering and adhesive and 35-65% relative humidity
for not less than 48 hours before installation. Typical cure time 24-48 hours, depending on temperature and relative
humidity.
3. Spread the adhesive using the specified trowel- carpet – 1/8 x 1/8 x 1/8 V-notch, 12 yds/gallon; sheet goods 1/16 x 1/16
x 1/6 V-notch, 20 yds/gallon. Allow the adhesive to tack properly (10-15 minutes) maintaining the proper trowel notch
throughout the entire installation.
4. Lay floor covering into the adhesive so as to minimize air bubbles and wrinkles. Check a small area for 100 percent
transfer. Roll the floorcovering in both north-south and east-west directions.
5. Keep the installation dry and at room temperature while curing. Exposure to water or rain will wash away the uncured
adhesive.
6. Clean up tools or adhesive spills with water while wet, use safety solvent when dry